| As you can see-the router base doesn't take
standard size guide bushes, a pity as I have a small collection. |
 |
| I removed the screws holding on the original
plastic base and removed it. There is a plastic bit to fit to your
router-this then centres the new base on your router. |
 |
| There are lots of predrilled holes in the
base-fit base over the guide bit and then spin it around until suitable
holes are revealed. Only two holes lined up on mine so I had to drill the
third out, using the original as a template. |
 |
| All done and ready to rout! It only took five
minutes to fit and now have two routers set up to save swapping bits!
(lazy, I know) |
 |